Approved Work Item
ISO/AWI 25654
Plastics — Reference materials for the validation of microplastic detection methods
Reference number
ISO/AWI 25654
Edition 1
© ISO 2025
Approved Work Item
Under development
A working group has prepared a draft.

Abstract

This document specifies the production of reference materials for the validation of microplastic detection methods. It refers to top-down procedures to produce irregular shaped powders. The longest dimension in size of the produced reference materials is between 10 µm and 1000 µm. This document applies to thermoplastic polymers. This document does not apply to the production of fibres, elastomers, epoxy resin or road wear tyre particles. It excludes artificial aging and bottom-up methods.

General information

  • Status
     : Under development
    Stage
    : New project registered in TC/SC work programme [20.00]
  • Edition
     : 1
  • Technical Committee :
    ISO/TC 61/SC 14
  • RSS updates

Life cycle

Sustainable Development Goals

This standard contributes to the following Sustainable Development Goals

12
Responsible Consumption and Production
14
Life Below Water
15
Life on Land

Got a question?

Check out our Help and Support

  2. Store
  3. Standards catalogue
  4. TC
  5. ISO/TC 61/SC 14
  6. ISO/AWI 25654